Trouble with bunkend being even

[campercross]

I recently financed a 2020 coachman clipper vtrec v1. When I went to set it up myself I realized that the front bunk won't slide all the way out on one side (the side the sink is on). It almost looks like I could just move the slide on the bunk forward so it would allow this side to come out all the way. But dont want to screwit up worse. Any ideas?

The pin is down on both sides but the one corner is sticking out 2 inches.

 

[PopUpSteve]

Are you sure it’s no caught on anything?

 

[campercross]

Are you sure it’s no caught on anything?

No it's not. I'm thinking the slides weren't attached even. Both sides have different measurements regarding the slides. If something was stopping it I don't think the pin would set in place

 

[campercross]

Thinking of pulling it out and unscrewing the faulty side so it allows me to put the bunk in the correct spot and screwing it back on.

 

[PopUpSteve]

Did you get it from a dealership? If so, take it back and demonstrate the problem to them.

 

[campercross]

That crossed my mind as well. It's just that it's a few hour drive one way to get to the dealership. Thanks for your help.

I might try to move the one side but if it starts to seem overwhelming I'll just put it back together and see what the dealership says.

 

[1380ken]

It makes no sense. How could the slide be mounted in the wrong spot?

 

[NLB]

At least call the dealer, maybe do a video chat.

 

[PopUpSteve]

It's just that it's a few hour drive one way to get to the dealership.

Did the dealership not do a setup and inspection with you before you took it off the lot?

 

[Sjm9911]

Is your camper level when setting this up? Front to back , side to side? If its newer from a dealer, I would have them fix it. Yea its a pain, but if you do something and it doesn't fix it they may say you broke it.

 

[campercross]

So when I measure the slide placement the measurements are off. On the other end they are identical. I assume humans put them together, so in my mind it's a mistake. I'll call the dealer today and ask about a video chat. Thanks for all the input.